Tag Archives: figure skates

How to Mold Ice Skates to Your Feet

When you get skates, they are manufactured to a typical shapes and size to match as many shopping for skatespeople’s feet as possible. Skaters can improve the fit by molding their skates to the form of their feet. This is done for a couple of factors – but mainly to create a snug fit which can minimize injury.  It needs to be stated however, that baking skates is something that is better reserved for superior quality skates.

Inexpensive skates which cost a little less are made from plastics which are most likely to tear when warmed.  Better skates are priced much more, but are often made from expensive materials like Kevlar as well as leather making them stronger, lighter and also better at taking in impacts.

Warning:  if you’re uncertain concerning the best ways to bake skates, even after reviewing this, do take them to your local skate store to have them done professionally.

How to Heat Mold Ice Skates

  1. Pre-heat your stove to around 180F (80C).
  2. While the oven heats, loosen up the shoelaces on your skates and remove the insoles.
  3. When the temperature has been reached, turn off your oven.
  4. Place a silicone baking sheet on a rack in the oven and place your skates on top of it.
  5. Leave you skates in the cooling oven for 5-10 mins, up until they are flexible and also easier to bend.
  6. Make sure not to let them cool too much!
  7. Remove your skates carefully from the oven and also change the insoles
  8. Place your feet in the skates, with your heel strongly in the heel of the boots.
  9. Very carefully lace up your skates by pulling the shoelaces out side-ways to stay clear of placing stress on the eyelets.
  10. At the very same time, mold the skate to the shape of your feet.  Leave you feet in your skates to cool for at least 15 minutes.
  11. When the skates have cooled down, unlace them, and remove your feet.
  12. Set your skates aside for a more 24 hrs to guarantee they are fully cooled before using them